Products

Rejector Systems

INQUIRY
Anritsu
Rejector Systems

With over 50 years’ experience in the design and manufacture of inspection and detection equipment, ANRITSU provide the best solutions that suit our customers' needs.
 
It is common to place a rejector system after an inspection system at the food facility for the below reasons.
1. Prevent the production downtime from stopping the line when the error occurs.
2. Prevent a careless mistake (put back defective products to the line) by an operator.


Flipper Type
The most common type of rejector is the flipper. NG products are pushed aside by the rejector gates (arms). It is ideal for products in boxes and thick bags.
 
Rejector SystemsAnritsu Rejector Systems
 
Introduction video: 
 
 
 
Dropout Type
The rejection conveyor drops down to reject NG products. It is ideal for products in thin bags.
 
Rejector SystemsAnritsu Rejector Systems
 
Introduction video:  Dropout Type
 
Up and Out Type
The rejection conveyor flips up so that the NG product drops out of the line. It is suitable for products in thin bags.
 
Rejector SystemsAnritsu Rejector Systems
 
Introduction video:  Up and Out Type
 
 
 Air Jet Type
NG products are blown sideways off of the line by a powerful blast of air. It is ideal for small, lightweight packaged products at high speed.
 
Anritsu Rejector SystemsAnritsu Rejector Systems
 
Introduction video:  Air Jet Type
 


Trip Type
In this unusual belt method, NG products are carried off either left or right by belts running crosswise to the product flow. It is suitable for rejecting large packaged products.
 
Anritsu Rejector SystemsAnritsu Rejector Systems
 
Pusher Type
NG products are pushed off the line sideways by the action of a gate attached to an air cylinder. It is suitable for rejecting products in packages and thick bags.
 
Rejector SystemsAnritsu Rejector Systems
 
Introduction video:  Pusher Type
 
 
 Turning Type
This method uses a turning gate to reject NG products. It is suitable for rejecting products in large packages and in thick bags at comparatively highspeed.
 
Rejector SystemsAnritsu Rejector Systems
 
Carrier Type
NG products are sorted horizontally without any shock due to rejection. Since the rejection process doesn't cause any damage, it is ideal for fragile products.
 
Rejector SystemsAnritsu Rejector Systems
 
Chute Type
Rejected products fall when the chute is reversed. It is ideal for rejecting relatively light bulk products.
 
Anritsu Rejector SystemsAnritsu Rejector Systems
 
Introduction video:  Chute Type
 
 
 Shuttle Type
The conveyor on the rejector slides to let the rejected products fall during the rejection. It is ideal for unpackaged animal products and sticky bulk products.
 
Rejector SystemsAnritsu Rejector Systems
 
Introduction video:  Shuttle Type